Art3dwallpanels 3D PVC Wall Panel for Interior Wall Decoration 33 Pack Textured 3D Wall Panels

• Real 3D Design: Diamond pattern with 30×30cm relief design makes our wall panels more eye-catching. One box contains 33 tiles, covering 2.97㎡.
• Become your own designer: Easy to make, no specialist knowledge required. Design your own 3D accent wall panels. Replace boring walls and give your room a new look.
• Quality material: This textured wall panel is made of premium PVC material, thin and lightweight, easy to install. Waterproof and fire resistant features make this panel more sturdy and durable.
• Wide application: Add a new decoration to the wall of your home! Perfect choice for living room, bedroom, playroom, bathroom, feature wall, ceiling, asylum. In practice, any type of interior decoration, both residential and commercial.
• BRAND GUARANTEE: Every customer is in good hands, we guarantee the delivery of a good quality item to our customers, refund for any defect and damage.

3D Wall Panel Installation Manual 1. Preparation for the wall All base walls must be flat, dry, clean and compact. If the wall has aged , the surface should be painted with water-based primer to fix the loose surface first. 2. Preparation for the wall panel. Open the box and take out the panels very carefully. Put the panels on the clear and dry floor for 24 hours to balance the moisture between the panels and the environment, to avoid excessive expansion or contraction after installation. 3. Measure the wall Measure the size of the wall to find out the center point of it, then mark vertically and horizontally. Place it on the floor by turning the panels before attempting to install, ensuring the correct installation of the desired model. 4. Install the goods on the wall. Put the strong adhesive on the bottom of the panel, to put the sticker higher than the back panel. Apply the panels to the very wall of the planned design, pressing the edges of the panels to ensure that all the panels adjacent to the wall firmly, clean the glue that flows out of the panels. It will be better to set aside two hours for drying, then move on to the next step. 5. Cut Panels If meet the angle or electrical outlet of the wall part, we can draw the line one of the panel, then use the knife or electric saw to cut the panels freely according to the line to fit the wall situation. 6. Trim edges and paint If the cut edges of the panels meet the corner or end of the wall, fill the cut edges with sheet rock compound/acrylic caulk. If additional finish is required, paint the panels with oil based paint.