ALIRANTA 5 pieces! (Not compatible with BS BiSecur remote controls) Black

• 5 pieces! Duplicates your Hörmann 868.3 Mhz remote control: HSM2 868 (blue buttons) / HSM4 868 (blue buttons) / HSZ1 868 / HSZ2 868 / HS1 868 (blue buttons) / HS2 868 (blue buttons) / HS4 868 (blue buttons) / HSE2 868 (blue buttons) / HSP4 868 (black buttons) / HSD2 868 (Not compatible with Hörmann BS BiSecur remote controls.)
• Small and compact design with sliding lid.
• Fast cloning process. Clones within 10 seconds.
• Battery, key fob and programming instructions (German and English) included;
• Distance: Extra long range. Up to 100 m. Better quality than original Hörmann remote control."

x high-quality clone remote controls for Hörmann 868.3 MHz, clones your Hörmann remote control 868.3 MHz with blue buttons. 5 pieces! Duplicates your Hörmann remote control: HSM2 868 (blue buttons) / HSM4 868 (blue buttons) / HSZ1 868 / HSZ2 868 / HS1 868 (blue buttons) / HS2 868 (blue buttons) / HS4 868 (blue buttons) / HSE2 868 (blue buttons) / HSP4 868 (black buttons) / HSD2 868. Note: Not compatible with Hörmann BS BiSecur remote controls!!! Technical data: Frequency: 868.3 MHz (learning code) Buttons / commands: 4 (control up to 4 different drives) Battery, key fob and programming instructions (German and English) included; Clone remote control: First you need to delete the remote control: 1) Press and hold the LOCK and UNLOCK buttons together - LED flashes three times. 2) Hold down the LOCK button and press the UNLOCK button three times. LED starts flashing continuously. The clone remote is cleared and ready for cloning. Then you need to clone your original remote control: 1) Place the two remote controls next to each other or one behind the other (II). Make sure you have contact with each other and touch each other. 2) Press and hold one button on your original remote and one button on your clone remote. Hold down both buttons until the LED: flashes 2 x > flashes 3 x > permanently on = The clone has only been successfully cloned when the light stays on permanently. If the cloning process does not continue after the 2 flashes, this means that the signal is not going through. Please move the remote control up and down slowly until you reach the point where it goes through. Note: You do not need access to the control panel or radio receiver. If you car sun visor clip https://www.amazon.de/dp/B07FVW7F59 If you want to increase the remote control reception range to 150-200 meters, you can connect this antenna: https://www.amazon.de/dp/ B01MZYAPVN/