VilogaRC A3 Super4 Hobbyeagle Flight Controller 6-Axis Gyro Stabilizer Full Set with Program Card for Fixed Wing RC Airplane FPV Aircraft Models (A3 Super4 Full Set)

• A3 Super 4 is a high-performance and functional 6-axis gyro and stabilizer designed for R/C airplanes. The hardware has been improved yet again based on the successful previous generation.
• PWM, PPM and multi-protocol serial digital receiver support and customizable output channels added to make the gyro more user-friendly and reliable.
• 6 flight modes and 6-position switching, including GYRO-OFF, NORMAL, LOCK, ANGLE, LEVEL and HOVER modes.
• Dual aileron and dual elevator system, flying-wing (delta-wing) and V-tail supported.
• Firmware upgradable and Programming Card supported.

Product description Features: 32-bit MCU, high-precision 6-axis MEMS sensor, improved hardware and stable firmware provide more reliable performance. 6 flight modes and 6-position switching, including GYRO-OFF, NORMAL, LOCK, ANGLE, LEVEL and HOVER modes. User defined mode supported. PWM, PPM and multi-protocal serial digital receiver supported. Customizable output channels and 2 pass-through auxiliary channels. Dual aileron and dual elevator system, flying-wing (delta-wing) and V-tail supported. Remote master gain supported. Firmware upgradable and Programming Card supported. Serial Receiver Protocols Supported: PPM Receiver Futaba SBus (compatible with FrSky SBus, JETI SBus, RadioLink SBus, TBS SBus and WFLY WBus) Spektrum DSM2/X 1024 Satellite (Remote) Receiver Spektrum DSM2/X 2048 Satellite (Remote) Receiver Spektrum SRXL Multiplex SRXL / JR XBUS Mode B Graupner SUMD FlySky iBus JETI EXBus TBS/ELRS CRSF Specification: Main controller: 32-bit microprocessor Built-in sensors: High-precision MEMS 6-axis sensor Gyro range: ± 2000 dps Acceleration range: ± 4g PWM output: 800 ~ 2220uS, median 1500/1520uS, frequency 50Hz ~ 333Hz Working voltage:DC 4.8V ~ 8.4V Working temperature: -10℃ ~ 50℃ Dimensions: 43×27×14mm (L×W×H) Weight: 10g (without connecting cable) Package Included: 1 x A3 Super 4 Main Controller 1× Program Card 1×LED module 3 x Receiver Cable 1 x Data Cable 1 x Adapter 2 x Double-sided Tapes Directions 1. Remove the A3 Super 4 Main Controller from its packaging. 2. Connect the receiver cable to the controller and your RC airplane. 3. Connect the data cable to the controller and your computer. 4. Install the Programming Card and follow the instructions to configure the flight controller. 5. Attach the LED module to the controller. 6. Power on the controller and your RC airplane. 7. Follow the 6 flight modes and 6-position switching to control your RC airplane. Safety Warning use only