78 Inch/2M Grey Wet Room Floor Water Barrier, Silicone Shower Threshold Water Barrier,Screen Door Seal Strip,Shower Tray Sealing Strip,Water Retaining Dam for Bathroom Bath Sink(L Shape,3cm High)

• How To Installation:First clean and dry the surface, measure and cut the wet room floor water barrier to your length, peel off the red adhesive back strip, stick to the Smooth Surface.NOTION:For Long Use, It Is Must To Use Silicone Sealant(Glue) To Fill The Edges Of The Water Barrier And Dry For 24 Hours Until The Sealants Is Solidified(The Package Do Not Contain Silicone Sealant)!!!
• High Quality Material:The shower water barrier strip is made of high-quality sillicone material, which is resistant to corrosion, high temperature, and abrasion. The shower sealing strip is soft and does not hurt your feet. The water dam is very easy to clean and maintain, just wipe it with a damp cloth.
• Bendable Water Flow Blocking Strip:You can bend it according to the environment to achieve water blocking effect.The length can be cut by a cutter to more accurately fit the use scene.
• Application: The silicone shower screen can be pasted on almost any SMOOTH surface, including walls, floors, tiles, etc. The silicone waterproof screen can be used on the edge of the sink to prevent water from falling on the floor and keep the floor dry.
• Warm Note: Size: 400cm L x 20mm W x 30mm H.The silicone floor seal is only 30mm in height,which cannot meet the requirements of barrier-free showers and large water holding areas .please contact us for any question about the bendable water dam,we will provide you with a satisfactory solution within 24 hours.

Attention: In order to achieve a stable and long-lasting effect, please pay attention to the following question This floor joint suit for smooth flat floor types, such as smooth marble floor, cladding floor and other smooth surface. can not use for severe sagging and ridges floor, large space floor and glass mosaic. Buy a size 5cm-10cm longer than the required length! Use with silicone sealant: Fill the space between the walls with both ends of the water barrier and all around the bottom by the silicone sealant to achieve a completely airtight effect, remove excess glue to make the contact smooth. Clean the floor and dry it before installation! Do not peel all stickers once:Mark the position and measure the appropriate length before peeling the sticker, peel the sticker little by little one side, then press the peeled position on the surface at the same time, then peel to the left little by little. Do not peel all stickers for once and pull the tape back from the water if found its not well installed. After the installation is complete, it should be kept dry for 24 hours and should be postponed for 1-2 days in autumn and winter. Installation method: Measure the length and width of the countertop, In the corner we recommend cutting it to 45 degrees, and then connecting two parts to ensure its firmness. Tear off the adhesive: in this process avoiding dust on the adhesive tape and affecting its adhesion. Paste: apply the seal of the water dam gently and slowly, keeping it horizontal or vertical, gently pressing with your fingers. Glue: The most important and necessary step is to fill the bottom edge of the water retention strip with caulking to ensure a long lasting and strong adhesion.