Shower Seal for Screens, Doors or Panels | Fits 4, 5 or 6mm Glass | Seals Gaps of Up to 16mm | 80cm, 90cm, 140cm or 2m Long | SEAL106 (80cm)

• Fits 4-6mm Glass
• Will seal gaps of up to 16mm
• The fin will fold back on itself if your gap is smaller
• Commonly used with a corner piece which can be purchased on this listing
• Available in lengths of 800, 900, 1400 or 2000mm

SEAL106 SEAL106 is a straight fin shaped seal that is most commonly found on the bottom horizontal section of a bath shower screen or shower door but can also be used vertically on the upright of the glass. This seal can be pushed into place over any glass that measures between 4mm and 6mm and will not need any type of adhesive to hold it in place. This seal can also be used with our standard corner piece (available to purchase seperately) if required. This shower seal has a 16mm tall soft fin on the bottom of the U section which once pressed against a flat surface (e.g. your shower tray or bath edge) will compress and create a watertight seal. This seal also has an additional side deflector designed to sit facing the inside of the shower tray/bath, this will flick any water that runs down the glass away from the main seal and back into the shower tray/bath This seal is commonly used on L shaped screens along with our corner piece (CG001) which can be purchased on this listing. This seal is best used for straight glass, if you require this seal for curved glass then please contact us via email info@showersealuk.com as we can make them to order for curved doors. SEAL106 is available in 4 different lengths, choose from either 800mm (80cm), 900mm (90cm), 1400mm (140cm) and 2000mm (200cm). This seal can easily be cut down to your required length using a junior hacksaw, or if you prefer we can cut the seal down to the length that you require. Need any further help fitting or finding the correct seal? Send us a message and we would be more than happy to help and always reply within 24 hours.