ADT-Link M.2 key M NVMe External Graphics Card Stand Bracket with PCIe3.0 x4 Riser Cable 25cm 50cm 32Gbs For ITX STX NUC VEGA64 GTX1080ti (25CM,R43SG)

• Graphics card compatibility: support for new graphics cards shipped after 2015 (old graphics cards shipped before 2014 are not supported)
• Motherboard compatibility: Notebook, ITX/STX motherboard, NUC, only supports M.2 NVMe interface Does not support M.2 SATA interface, does not support M.2 WiFi interface, does not support M.2 WWAN interface
• Power Description: The model that supports the power supply is DELL 12V/18A/220W power supply, or the standard ATX power supply. Please prepare or purchase the power separately.
• Bandwidth speed: PCIe3.0x4 (32G/s)
• Supporting power supply is DELL 8-pin 12V/18A/220W, or standard PSU power supply. The power supply should be prepared by the buyer or purchased separately.

The length is customizable, the prices of cables of different lengths are not the same, please contact us if you need! Brand: ADT-Link Product Model: R3G Series Products Product Name: Graphics Card External Adapter Card Extension Cable Wire length: 25cm, 50cm (other bulk orders can be customized) Cable Length Description: The length of the R3G series cable is 25cm or 50cm, the next line length is 50cm. Refer to the blue dimension in the figure below. Installation steps: 1. Install the hexagonal copper post and insert the graphics card into the PCIe x16 connector. The screw is tightened so that the graphics card does not move or fall. 2. Install ATX or Dell power supply, including the graphics card power cord. After installation, the DELL power supply will turn on orange. 3. You can plug the M.2 cable when the computer is off. After power on, the ATX power supply will automatically start the fan to rotate. If you are using the LED power supply, the green light will light up. At this time, the R3G card will turn on two green lights. The system will recognize the card automatically. Please install the graphics card driver. Installing the driving process may prompt the computer to reboot. 4. Finish.