Lantelme Pull tabs 2 mm Joint Width 1000 tabs for Tile Height 3 to 15 mm tiling Tool for DIY and Professional Tilers 4832

• 2 mm joint width - 1000 tabs for large projects - For uniform spacing and quick installation. Includes tile laying aid, levelling tabs, tabs and clips for laying tiles.
• Precise levelling system for perfect tile laying - For even joints and a clean surface. Ideal for wall and floor tiles. Tile laying aid for DIY enthusiasts and professionals.
• For indoor and outdoor wall and floor tiles - Suitable for ceramic, natural stone, granite and more. This laying system makes tile laying noticeably and permanently accurate.
• Reusable Pull Tabs - Strong & Durable - Simply snap on, place tile, tighten The clips hold reliably and can be removed without leaving any residue after installation.
• Easy system - quick & clean processing - perfect for DIY enthusiasts: no tools required. Tile laying aid saves time and significantly reduces offset when laying tiles.

Lantelme tiling tool pull tabs DIY and professional tilers use this tile levelling system to ensure flat, even and level laying of tiles, flagstones, and granite and marble slabs across large and small areas of floors and walls. The Lantelme tile levelling system includes: 1000 pieces pull tabs for joint widths of 2 mm Advantages: - intended for small and especially for large tiles, as these tiles cannot easily be corrected. - easy, fast and perfect laying of tiles and slabs - joint widths ranging from 1 to 4 mm available - intended for both floors and walls - protruding edges a thing of the past - intended for tiles and slabs 3 - 15 mm thick How the tiling system works: 1. Using a notched trowel, spread the tile adhesive evenly over the floor. Next, take the tiles and line them up. 2. Now apply the pull tabs to the tiles one after the other. Check again that the tiles are in the correct position, as it is still possible to adjust as long as the adhesive has not set. 3. After laying the next tile, take a wedge and insert it into the pull tab before pressing the wedge through the pull tab with the special pliers until both tiles are level. 4. Continue this technique row by row. 5. Once the tile adhesive has dried after 24 hours, the tabs should easily break away along the tear line. This is best done with a gentle kick or a rubber mallet. 6. The plastic wedges can be reused. Examples of required tab quantities per square metre: 25 tabs for tiles sized 40 x 40 cm 11 tabs for tiles sized 60 x 60 cm 9 tabs for tiles sized 90 x 60 cm 7 tabs for tiles sized 90 x 90 cm 8 tabs for tiles sized 100 x 100 cm 8 tabs for tiles sized 120 x 60 cm 6 tabs for tiles sized 120 x 120 cm