ENT 10026 Solid Carbide Spiral Bits SC, Shank (S) 8 mm, Diameter (D) 6 mm, NL 22 mm, GL 70 mm

• Shank (S) 8 mm
• Diameter (D) 6 mm, Cutting width (NL) 22 mm
• Total length (GL) 70 mm, Flutes (Z) 2, Solid Tungsten Carbide (SC)
• Flutes (Z) 2, Solid Tungsten Carbide (SC)
• Router bits made of solid micrograin carbide with upcut spiral. Very efficient chip ejection, less power required, less heat production. Longer lifetime due to higher performance. Due to the continuous contact with the workpiece these bits give a chatter-free cutting result.

ENT spiral groove cutter VHW S8 Z2 D3-10x12-35 GL 60-90 mm. Cutter with ground spiral for better chip ejection. Thanks to the spiral ground cutting edge, the cutter works with a pulling cut. This creates a clean milling edge, and can also be worked with less pressure on the tool, which at the same time reduces the risk of breakage. Larger milling depths are milled in two operations. Item no. 10020 and 10022 with soldered solid carbide cutting edge in the shaft. Technical data: - Shaft (C): 8. - Cutting: 2 - Diameter (A): 3-10. - Width (W): 12 - 35. - Total length (GL): 60-90.