Zefal Tubeless Rim Tape, 25mm x 9m, Red

• Specially designed self-adhesive tape for sealing rims in preparation for conversion to tubeless tyre setup
• Twin-material Tubeless tapes were designed to guarantee remarkable pressure resistance and durability
• The addition of elastomer adhesive makes it possible to stop the sealant from infiltrating the rim
• Slight elasticity makes tapes fitting simpler without any creases or bubbles
• For use on 22-26mm internal width rims

ZEFAL Tubeless Tapes Zefal's twin-material Tubeless tapes were designed to guarantee remarkable pressure resistance and durability. The addition of elastomer adhesive makes it possible to stop the sealant from infiltrating the rim. Finally, their slight elasticity makes tapes fitting simpler without any creases or bubbles. All sizes 9 meters in length. Available widths: 20mm For use on 17-21mm internal width rims 25mm For use on 22-26mm internal width rims 30mm For use on 27-32mm internal width rims 36mm For use on 33-39mm internal width rims Mounting instructions Remove the tyre from the rim Remove the old rim tape Clean the inside of the rim with a dry cloth. Make sure to remove any glue residue in the case of a glued rim tape. Clean and degrease with a solvent. Unroll the rim strip over a distance of about ten centimetres. Stick one of the blue adhesive patch on the end of the tape. Stick the tape (with its patch) inside the rim. Position them about 2 spokes before the valve. Hold the wheel in one hand, and with the other hand, pull the tape tight. Correct positioning means a smooth band, without folds or bubbles. Stick the tape on the complete circumference of the rim. The end of the tape must have an overlap, ending about 2 spokes after the valve hole. Stick a second blue adhesive patch to finalise the installation. This prevents any lifting and thus prevents any future infiltration of the preventive product between the tape and the rim. Locate the location of the valve, perforate the tape with a sharp object, and insert the tubeless valve. Screw on the threaded lock and tighten firmly by hand. Proceed with the mounting of the Tubeless or Tubeless Ready tyre. Be careful not to use any tools to mount the tyre, as you could damage the rim. Inflate and fit the tyre on the rim (by using our Tubeless Tank inflation system or, failing that, a foot pump or compressor).