Wantec 2wIP 2-Wire Ethernet Adapter with PoE - BNC - Client | Camera Side | Receiver - 2-Port

• Cable length up to 1500 m for coax, 600 m for twisted pair or bell wire
• Transmission speed up to 200 Mbps per route
• Multiport, a 1-port transmitter can control up to 4 receivers, the 4-port transmitter can control up to 8 receivers
• PoE with up to 38 watts per receiver PoE function can be switched off on the receiver device
• No programming required for basic configuration, plug and play, plug in, run. Also works with SIP phones, access points etc.

2wIP E-Series basic device receiver (TX adapter - camsite) with two Ethernet/PoE outputs. An adapter from BNC male to 2-wire clamp connection is included. Features With the 2wIP, a network connection can be established via a 2-wire cable. PoE is also transmitted, so PoE devices (e.g. IP camera, SIP telephone, IP door intercom, etc.) can be operated without additional power supply. The 2wIP E-Series provides a bandwidth of up to 200Mbps on 2-wire or coaxial lines. Cable length up to 1500 m for coax, 600 m for twisted pair or bell wire transmission speed up to 200 Mbps per route multiport, a 1-port transmitter can control up to 4 receivers, the 4-port transmitter can control up to 8 receivers. PoE with up to 38 watts per receiver. PoE function can be switched off on the receiver device. No programming. basic configuration is necessary to basic Plug and play, plug in, run. Works of course also with SIP phones, access points, etc. Set up the connection 2-wire connection between transmitter and receiver, connection in the bus system, observe polarity. Plug the terminal device into the 2wIP receiver. Connect the 2wIP transmitter to the network switch using a patch cable (a PoE switch or PoE injector is required for transmitters for power over PoE). If a transmitter with power supply is used via the supplied power supply: connect the power supply to the 2wIP transmitter, then plug the mains plug into the socket. Done, the transmitters and receivers configure themselves.