Voilamart Ebike 48V 7A / 26A Sine-Wave Controller Accessories Components

• Allow you to swap two power modes between the full 1000W power or 250W power by a single blue switch wire is embedded in controller. (Only for Twist Throttle)
• Still remain the full 1000W power with no speed control. (Only for Pedal Assist System, "PAS")
• --Voltage fits with DC 48V; --Output Current: 7 / 26A; --Compatible for gearless motor, not for geared motor(Please confirm the hall cable of your motor is 5-pin 2x3 plug, not 6-pin 2x3 plug).

Upgraded Intelligent Motor Controller: * Allow you to swap two power modes between the full 1000W power or 250W power by a single blue switch wire is embedded in controller. (Only for Twist Throttle) * Still remain the full 1000W power with no speed control. (Only for Pedal Assist System, "PAS") 48V 1000W Brushless Motor Controller - Wiring Guide： Power Cables: No.1 Red Cable: Battery Positive (+) No.2 Black Cable: Battery Negative (-) Motor Phase Cables (3-Wire Bullet Plug): No.3 Yellow Cable: Motor Phase Wire - Yellow No.4 Green Cable: Motor Phase Wire - Green No.5 Blue Cable: Motor Phase Wire - Blue Hall Sensor Cable (5-Pin 2x3 Plug): Black Wire: Ground (-) Red Wire: Positive (+5V) Blue Wire: Hall Signal - Blue Green Wire: Hall Signal - Green Yellow Wire: Hall Signal - Yellow Throttle Cable (6-Pin SM Plug): Black Wire: Ground (-) Red Wire: Throttle +5V White Wire: Throttle Signal Yellow Wire: Electric Lock / Ignition Brown Wire: Positive (+) Green Wire: Battery Level Indicator Brake Lever Cables (2 Sets): Red Wire: Brake Signal (+) Black Wire: Ground (-) (For front and rear brake levers with motor cut-off switches) Light Cable (Max 5W): Red Wire: Light Power (+) Black Wire: Ground (-) PAS (Pedal Assist Sensor) Cable: Red Wire: Positive (+) Black Wire: Ground (-) White Wire: PAS Signal Speed Limiter / Road-Legal Wires: No.12 Blue 1-Pin Wire + No.13 Blue 1-Pin Wire: When connected (paired): Restricted power mode (road-legal) When disconnected: Full-power mode (unrestricted) Note: This controller uses cylindrical bullet plug connectors for motor phase wires and 6-Pin SM connectors for signal and throttle cables. Battery level display into the throttle grip - not for separate display screen.