Upgraded 500ml UV Resin Transparent Ultraviolet Solar Quick 1min Curing Epoxy Resin Glue for Resin Molds Jewelry Making DIY Crafts Pendants Earrings Bracelets, with 6W Portable Mini UV Lamp

• WHAT'S NEW: Based on customers' feedbacks and several developments, we proudly introduced our new developed UV resin, which has even better transparency, lower viscosity, and most importantly, much faster curing.
• QUICKER: The new upgrade resin can be cured completely hard under a 6W mini UV lamp in only 2 minutes (1 minute curing for both sides), which means less time and lower wattage needed for the curing process, hugely advanced comparing to our past version (4 minutes under 36W). You can also put the resin under direct sunlight and it won't be slower.
• HIGHER QUALITY: Undoubtedly excellent transparency, 100% crystal clear and non-yellowing, with hard glassy finish and uniform gloss. Less shrinking, less bubbles, lower viscosity.
• EASIER: No preparation is required for the resin. Specially designed nozzle make it easy to control your drops. Perfectly suited for resin jewelry making and crafts decorations, resin pour art, paint, garment accessories and other DIY crafts.
• SAFEST: Non-toxic, no harsh chemicals, cruelty free materials. Material safety datasheet available for checking. Note: This product is sensitive to light and heat and needs to be stored in a cool, dry place, protected from light.

Package: 5 x New Upgrade UV Resin (volume of each: 100ml) 1 x USB-powered UV / LED lamp 6W (with USB cable) Instructions: -Directly pour the resin in the mold or the bezel. -Add the pigment, glitter, dried flowers or anything you want in it using a toothpick or tweezers, and cure the resin with UV light. -Gradually add the amount of the pigment to adjust the color instead of pouring too much pigment at a time. How to avoid bubbles: 1. UV resin should be poured in silicone molds in layers, allowing air bubbles completely escape. 2. To expedite the process of escaping of bubbles and time of solidification of resin, the mold can be a bit warmed up. For example, heat the oven to 80℃(176℉), turn off, ventilate it a little and filled the mold with the resin. 3. Before using the resin, place it upside down to prevent air bubbles from escaping during extrusion. 4. Use a toothpick to concentrate the air bubbles on the surface of the resin. Puncture them with a pin or undo them by applying heat with a heat gun or a lighter. Attention: -Avoid contact with eyes, skin and clothing. -If you accidentally splash into your eyes, rinse immediately with plenty of water. -Rinse immediately with soapy water after skin contact. -Keep out of reach of children. -Store the product in a cool, dry place, protected from light.