Treatex Ultra Colour Tone - Light Oak 181e = 1 LTR

Product description Treatex Colour Tones have been designed to give you a beautiful range of colours with which you can change how your floors, doors, stairs and worktops look and feel, without hiding the grain or the natural beauty of the wood. This allows you to match the colours in your home when every piece of wood is different, being that every tree is unique. Treatex Colour Tones penetrate deep into the wood and enhance its natural beauty, manufactured on a base of natural sustainable raw materials and then completed with natural pigments used to colour the oils. 0.5L will cover approximately 10m² in one coat depending on the timber and method of application. 1L will cover approximately 20m² in one coat depending on the timber and method of application. 2.5L will cover approximately 50m² in one coat depending on the timber and method of application. Please note! Clear Hardwax Oil must always be used as the final coat when Natural Hardwax Oil or Colour Tones are applied* *Natural can be used as a top coat with Spruce Colour Tone to achieve a pure bright white Preparation Sand the surface to smooth bare wood using 80-120 grit sandpaper. Ensure that any previous finish has been fully removed. Remove dust, dirt and any other contaminates which may lead to uneven absorption of Colour Tones. Make sure the surface to be treated is thoroughly dry. Stir tins and ensure product is at room temperature before use. Enough Colour Tone should be purchased to complete the whole project and when more than one container is required it is advisable to mix them together before use. Various species of timbers will take colours differently, we strongly advise a small trial application prior to starting a project. Application One coat of Colour Tone should brushed or rolled on. A second coat of Colour Tone is usually unnecessary and will deepen the colour. To ensure an even colour, remove excess product from the surface with a lint free cloth. Allow to dry - maintaining warmth and ventilation Directions 1. Prepare the surface by sanding and removing dust. 2. Stir the product and apply one coat with a brush or roller. 3. Remove excess product and allow to dry.