T&C™ 38mm-40mm Kitchen Worktop Finishing Profiles 6mm Radius Top & Bottom - Hand Finished - Satin Silver Finish (630mm Long Worktop End Cap)

• 38mm-40mm Kitchen Worktop Finishing Profiles 6mm Radius Top & Bottom - Hand Finished - Satin Silver Finish (630mm Long Worktop End Cap).
• This worktop end trim will suit 38mm - 40mm thick worktops that feature a 6mm radius to the top and bottom long edge profiles. Install using silicone to seal any raw worktop edges to prevent water ingress, and secure the trim in place with countersunk wood screws. This cover trim will suit worktops up to 620mm deep, for deeper worktops our breakfast bar trims can be used in the same way.
• Worktop end trims are flat aluminium plates that cover the end of a worktop run, they feature a curved top lip that sits on the top surface of the worktop approximately 2mm high covering any chipped edges within 5mm of the worktop edge. Each end of the trims are profile matched to the worktop so they will fit either a left, or right hand installation once the appropriate end is cut down with a hacksaw to the desired length.
• This metal worktop end cover trim from Design Hardware features an anodised aluminium satin silver finish that coordinates with many kitchens. This end trim reduces time and simplifies installation and covers exposed worktop ends, providing a durable alternative to laminate edging, and dissipates heat when worktops are fitted next to free standing cookers.

38mm-40mm Kitchen Worktop Finishing Profiles 6mm Radius Top & Bottom - Hand Finished - Satin Silver Finish (630mm Long Worktop End Cap). This worktop end trim will suit 38mm - 40mm thick worktops that feature a 6mm radius to the top and bottom long edge profiles. Install using silicone to seal any raw worktop edges to prevent water ingress, and secure the trim in place with countersunk wood screws. This cover trim will suit worktops up to 620mm deep, for deeper worktops our breakfast bar trims can be used in the same way. Worktop end trims are flat aluminium plates that cover the end of a worktop run, they feature a curved top lip that sits on the top surface of the worktop approximately 2mm high covering any chipped edges within 5mm of the worktop edge. Each end of the trims are profile matched to the worktop so they will fit either a left, or right hand installation once the appropriate end is cut down with a hacksaw to the desired length. This metal worktop end cover trim from Design Hardware features an anodised aluminium satin silver finish that coordinates with many kitchens. This end trim reduces time and simplifies installation and covers exposed worktop ends, providing a durable alternative to laminate edging, and dissipates heat when worktops are fitted next to free standing cookers.