Super Cool Creations Clock Mechanism & Black Hands Kits, Silent Sweep Non Ticking, for up to 3mm thick clocks (4)

• Superior Quality & Build, Quartz Sweep Extra Quiet Clock Mechanism & Hands Kit - (Non Ticking)
• QUIET!! Quartz Sweep (Quiet Non Ticking) Clock Movements. The second hand moves in a smooth continuous sweeping motion instead of one second steps and the case is sturdier, It does not tick and keep you awake. Supplied with all fittings, short spindle for up to 3mm clock thickness. HANDS - Black 56mm plastic clock hands 56mm from centre of minute hand hole to tip of minute hand & Black second hand
• Movement fixing instructions The brass thread is on the movement spindle which makes assembly of the clock very easy and provides protection to the plastic spindle. To make a clock simply drill an 8mm to 10mm hole in the dial. Place the rubber washer (supplied) over the movement spindle and push the spindle through the hole from the back of the dial Place the brass washer (supplied) over the spindle.
• (This covers any small chips or ragged edges around the hole Then just tighten the brass nut (supplied) on the thread until the movement is held firmly. Push the hour hand then the minute hand and then the second hand on to the spindle making sure they all point to the 12 Put in the battery (not supplied) and that’s it - your clock will start!

Superior Quality & Build, Quartz Sweep Extra Quiet Clock Mechanism & Hands Kit - (Non Ticking) QUIET!! Quartz Sweep (Quiet Non Ticking) Clock Movements. The second hand moves in a smooth continuous sweeping motion instead of one second steps and the case is sturdier, It does not tick and keep you awake. Supplied with all fittings, short spindle for up to 3mm clock thickness. HANDS - Black 56mm plastic clock hands 56mm from centre of minute hand hole to tip of minute hand & Black second hand Movement fixing instructions The brass thread is on the movement spindle which makes assembly of the clock very easy and provides protection to the plastic spindle. To make a clock simply drill an 8mm to 10mm hole in the dial. Place the rubber washer (supplied) over the movement spindle and push the spindle through the hole from the back of the dial Place the brass washer (supplied) over the spindle. (This covers any small chips or ragged edges around the hole Then just tighten the brass nut (supplied) on the thread until the movement is held firmly. Push the hour hand then the minute hand and then the second hand on to the spindle making sure they all point to the 12 Put in the battery (not supplied) and that’s it - your clock will start!