Solvent Weld White 40mm (43mm) Waste Pipe Swept Bend - Pack of 2

• This product is made to be installed with 43mm (known as 1 1/2 inch solvent weld) pipe or fittings. If your pipe or existing fittings measure 40mm then this product is not compatible and you will require 40mm pushfit or compression fittings.
• This listing is for a Pack of 2
• Solvent weld waste pipe swept bend designed to join 2 waste pipes in a gradual 90 degree configuration, increasing flow rate due to the more gentle bend.
• Solvent weld fittings are secured using solvent weld cement for a permanent and strong installation.
• This is for waste water use and not rainwater drainpipe use which is a different product.

Buy a Solvent Weld 40mm (Actual Pipe Size is 43mm) Waste Pipe 90 Degree Swept Bend - White from a large range of Solvent Weld Elbows in our Solvent Weld (ABS) Pipe & Fittings section. Important Note: Solvent Weld Waste Pipe fitting sizes are often stated in metric standard measurements, however the actual pipe size is measured in imperial. The three options are as follows - 32mm Solvent Weld Pipe actually measure 1 1/4 inchs or 36mm, 40mm Solvent Weld Pipe actually measure 1 1/2 inchs or 43mm, 50mm Solvent Weld pipe actually measure 2 inchs or 56mm. In addition if the term "ABS" is printed on the pipe this identifies the pipe as solvent weld waste pipe.