Slate Vent for Extractor Fans for 600 x 300 mm & 24 x 12 inch Roof Slates - Bathroom or Soil Vent Pipe

• FITS 600 x 300MM SLATE ROOFS — Designed specifically for standard 600 x 300mm (24 x 12 inch) roof slates. Replaces a single slate for a seamless, flush finish that blends into your roof
• EVERYTHING IN THE BOX — This package contains one slate vent and one 110mm pipe adaptor. Everything you need to connect your bathroom extractor fan through your slate roof. No additional purchases required. Need loft ventilation only? Search "Beddoes Products Slate Vent 600 x 300mm" for our vent-only package.
• STOPS DAMP AND CONDENSATION — Provides 10,000mm² of airflow to clear stagnant air from your roof space, preventing condensation build-up and protecting your timbers from rot, mould and costly structural damage
• UK DESIGNED AND MANUFACTURED — Built from thermoplastic in a UK facility, with an underbase that channels rainwater safely back onto the roof and a 4mm grille acting as an insect screen and baffle against wind-driven rain
• EASY TO INSTALL — One vent replaces one slate. Printed fitting instructions included. Minimum roof pitch 22.5 degrees.

Beddoes Products Slate Vent 600 x 300 mm with Pipe Adaptor Vent your bathroom extractor fan through your slate roof the easy way with the Beddoes Products Slate Vent and Pipe Adaptor package. Stop bathroom moisture at the source — before it causes damp, mould, and costly damage to your home. Whether you're a homeowner or a professional roofer, everything you need to connect your extractor fan through the roof is included in this package. What's In The Box Everything you need — one slate vent and one 110mm pipe adaptor. No additional purchases required. The Simple Way to Vent Your Bathroom Extractor Fan Through the Roof Simple to install — one vent replaces one slate 110mm pipe adaptor included — connects directly to your extractor fan flexible duct Have a 100mm fan outlet? — Search "Beddoes Products 110-100mm Reducer" to add one to your order Important: Check Your Roof Pitch Before Ordering This vent is designed for roofs with a minimum pitch of 22.5 degrees. Installation on a shallower pitch will prevent rainwater from draining correctly through the under-base, which can cause leaking. If you are unsure of your roof pitch, ask your roofer before fitting. Installed correctly on a suitable roof, this product is fully weatherproof and will outlast your roof. Size The Beddoes Products Inline Slate Vent fits any 600 x 300mm roof slate. The extra width created by the under-base fits under the slates next to it. Length - 600mm (24 inch) Width (of slate area) - 300mm (12 inch) Pipe Adaptor outlet - 110mm diameter The Technical Part UK designed and manufactured in thermo-plastic Under-base allows any water that comes in to run out through the bottom onto the roof 4mm grille acts as an insect screen and baffle against wind-driven rain Airflow capacity of 10,000mm² per unit Minimum roof pitch: 22.5 degrees