Shiwaki Keyhole Light Lamp, Wireless Auto Sensor Motion Detector Door Keyhole automatic sensor Light Tap Lights Night Light wall lamp

• MOTION SENSOR: Using Advanced PIR sensing technology, automatically identifies human body. Automatically turn on and auto-off after about 5 seconds,Sensor sensitive distance: 3 m.
• BRIGHT LED BULBS: This light only activates in darkness, 4 LED bulbs is bright enough to make sure the keyhole can be seen at night without keeping the porch light on.
• FOR ANYWHERE USE: This kind of small lamp offers ideal gentle light for the bedroom, baby room, closet, closets, cabinet, corridor, workshop, basement, garage, stairwell, oil depots, roof, door, drawer, trunk, garage entrances and other many places.
• BATTERY OPERATED: They are powered by 1 piece of AA batteries (not included), please make sure the batteries are right placed.
• INSTALL EASILY: Come with an adhesive sticker, it can be easily stuck on the door. Easily use and operate.

Installation method: 1. Use double-sided tape to fix (gift when leaving the factory) 2. Use M3.0X20mm screws to fix the base (the screws need to be provided by yourself) troubleshooting: 1. When the power is turned on, the light does not light up. Solution: A. Check the battery installation B. When the ambient light is too bright, the light is on standby. C. The battery is out of power, please replace the battery. 2. When the power is turned on, the LED light flashes. Solution: A. The host needs one to two minutes to stabilize the internal circuit. B. The battery power may be low, please replace the battery. Precautions: 1. Do not put the product in a place facing the glass door or where the temperature changes drastically, 2. Because this product uses an infrared sensor, it needs a relatively stable environment. 3. Please place the light away from monitors and TVs. 4. Please pay attention to the temperature and humidity of its working environment, otherwise the battery life will be affected. 5. Use good quality LR06 (AA) AA batteries or rechargeable batteries. 6. After the light goes out, delay time of 6-8 seconds, then work again. 7. Do not shoot LED lights directly into people's eyes, especially children. 8. When installing the product, do not install it in a place where children can easily get it, so as to avoid accidents to children