KATSU Layflat Discharge Hose Pipe 20m x 38mm 1-1/2 Inch Diameter with 2 Clips Odour Free for Submersible & Other Water Pumps, Draining Pond, Garden Irrigation, Hot Tub, Swimming Pool or Sump 664345

• 20m Layflat Discharge Hose with 38mm diameter, compatible with most water pumps
• Quality made with NO smell
• Lasts much longer than the traditional nylon hose
• Suitable for Working Pressure of 0.8 MPa
• Ideal for filter pump, draining swimming pools, ponds, ditches, flooded areas, hot tubs, pump irrigation ect

Suitable for working pressure of 8KG(0.8mpa) blasting pressure: 3.9 Mpa(39kg) product caliber: Φ1.5 inch product length:19. 5-19. 7m Under the normal atmospheric pressure:below -5 degrees, the water pipe will not get harden and can tolerable 65 degrees. Applicable place: residential area, business district, ship, industry, agriculture, petroleum, chemical industry and other operation manual: (1) hose connection: when the fire hose is on the water hose interface, it must be covered with a layer of soft protective material and then tightly secured with galvanized iron wire or throat hoop. (2)The use of water belt: When using fire hose, the high pressure water belt should be attached to the place near the water pump. The water belt should prevent the torsional or sudden bend after the water filling. At the same time, it should prevent the damage of the water belt interface collision. (3)When laying water belt: When laying water belt, we should avoid the sharp objects and various kinds of oil. When laying the water belt to the high place, we should use the water belt hook. When laying the water belt through the main traffic road, the water belt should be padded with the bridge. When passing the railway, the water belt should pass under the track to avoid the water belt interrupted by the wheel rolling and discontinuous water supply. (4)To prevent freezing:during the severe winter season, when the water supply is needed to stop in fireground, the water pump should be operated slowly to keep the water volume smaller. (5)Water belt cleaning: after the use of the water belt, cleanit is necessary.The water belt which transport the foam, must be meticulously washed, to protect the film. In order to clean the oil on the water belt, can be washed with warm water or soap.The frozen water belt, first to melt, and then clean it,make it dry, wet water tape shouldn't be stored.