KOYOFEI 2PCS Resin 3D Printer Plate, Building Plate and Magnetic Sheet, Flexible Steel Plate, Flexible Bed for Elegoo Saturn 3D Printer, 196 x 126 mm

• Flexible and magnetic plate: The surface of the steel plate CNC surface drawing treatment, which has good adsorption to prevent the model from falling off during printing.
• Strong and durable stainless steel material: The magnetic printing plate is made of high-quality stainless steel material and has good elasticity. It can be quickly returned to its original state after bending and removing the model and reused again.
• About the size: The size of the magnetic steel plate is 196 x 126 mm and the thickness of this plate is 2.7 mm, compatible with Elegoo Saturn. Due to the thickness of the product itself, the printable height of the 3D printer is reduced by 2.7 mm, you can print a spacer to compensate the difference. At the same time, after installing the magnetic printing plate, you need to re-level the 3D printer to achieve excellent printing results.
• Unique handle design: The magnetic printing plate is equipped with a handle that makes it easier to install and remove the magnetic printing plate.
• Installation tips: First clean your building plate very well, allow it to dry, connect your magnet to the plate, leave it for a while to fully sit and then reset the levelling settings of the printer to start printing process.

2 x magnetic LCD/DLP resin 3D printer building plate for Elegoo Saturn. Installation instructions: Please clean your building plate thoroughly and allow it to dry. Please connect your magnet to the plate and let it sit for a few hours (more than 24 hours is better) so that it sits completely. Please install the spring steel plate on the magnetic base. Please reset the levelling settings of the printer to start the printing process. Capabilities in use: When installing the soft magnetic film, make sure that the printing plate is clean and dry. After installation, it is best to keep it upside down or attach it with a clamp to ensure that the soft magnetic film is fully attached to the printing plate. Please make sure that the spring steel is fully aligned with the magnetic base to avoid the resin penetrating the gap during use, which affects the magnetic force of the soft magnet and causes the spring steel plate to fall off. If there are burrs on the surface of the spring steel, please use sandpaper carefully to ensure that there are no burrs before using it to prevent the burrs on the spring steel from penetrating the fluorinated ethylene propylene (FEP) film during the printing process. Do not bend the spring steel too much after printing when removing the model. After use, use alcohol or cleaning fluid to remove the resin residue on the surface. If after some time during the printing process, the model falls off the spring steel sheet, you can sand the spring steel sheet with sandpaper to ensure sufficient adhesion.