KOYOFEI 3PCS Mono LCD Screen Tempered Glass Protective Film for 9.25‘’ Resin 3D Printer, High Light Transmittance Protective Film for Anycubic Photon Mono X 6K, M3 Plus LCD Resin 3D Printer

• The light transmittance of the tempered film is 95%, which will not affect the light of the monochromatic screen to cure the resin in the resin tank through the tempered film.
• With good protection, the tempered film can not only protect the monochrome screen from being scratched by sharp objects in daily use, but also prevent the resin from leaking and polluting the screen from the damage of the release film.
• Compatible Models: 9.25 inch tempered glass protective film is compatible with Anycubic Photon Mono 6k, M3 Plus. It comes with tool kit and manual, please read the introduction of the manual before installation.
• Easy to use, the back of the tempered film is covered with a protective film. Please keep the screen clean before use, then remove the back protective film and install the tempered film on the monochrome screen. Use a plastic scraper to avoid air bubbles. After the installation is completed, please use cleaning fluid and The non-woven fabric wipes the tempered film clean.
• Small Tips:The tempered film has a thickness of 0.33mm. In order to avoid printing problems, it is recommended to level the 3D printer again after installing the tempered film.

9.25 inch monochrome screen tempered film for Anycubic Photon Mono X 6K, M3 Plus resin 3D printer. Installation Notes: Installation of Tempered Glass Screen Protector 1. Tear off the stained screen protector and clean the curing screen with tool kit. A. Wipe screen with alcohol prep pad B. Wipe screen with a dry wipe C. Use dust-absorber to remove fine dust. 2. Peel off the backing of screen protector. Align the protector with edge of screen and stick it from one end to the other. Get the installation carefully with out air bubbles. 3. Clean the screen protector front with tool kit.