Hakeeta Printhead for Printers,Professional printhead for The C4900A C4901A for The 8000 8500 Series,Print Head Replacements Accessories

• ★【Professional print head】This is a professional print head compatible with multiple models.
• ★【Smooth and natural】The print head is smooth and stable with natural colors. This is a printed matter that you deserve to have and to be replaced.
• ★【High reduction degree】High-quality ink with high reduction degree and enough ink can save your cost.
• ★【Stable and no paper jam】The nozzle has been polished, there is no paper jam, and the printing process is stable.
• ★【Imported raw materials】All Bayer raw materials from Germany are used, and the quality is guaranteed.

Specification: Color: Black / Yellow,Magenta / Cyan (Optional) Applicable models: for Z2100 / T1200 / T1300 / T610 / T620 / T1100 / T770 / T790 / / 8500 / K550 / K5400 / K5300 / L7580 Size: 90 * 60 * 20 mm / 3.5 * 2.4 * 0.8inch Weight: approx. 80-160g Package List: 1 or 2 * Print Head Note: 1.Please remove the polishing cardboard nozzle and remove the orange rubber plug before installation. 2.Avoid physical contact with the printhead holes and circuitry to avoid damage caused by electrostatic breakdown of electronic components. 3. Always check whether there is sufficient ink in the printer's ink cartridge and add it in time to avoid burning the printhead for lack of ink. 4. Printheads and ink cartridges should not be often removed or not installed for a long time, in order to avoid the ink supply pipe into the air resulting in discontinuous ink supply, nozzle ink shortage affects the printing effect or burn nozzle. 5.If prompted by "KY printhead failure" or "C head failure", try to remove the two printheads, use an eraser to gently wipe the circuit contacts of the faulty printhead, and then install and use. 6.When the printing effect is not satisfactory, the machine with the control panel can be executed in the panel "Settings" option "cleaning printhead" project. The properties will vary from model to model, and some models may not have this feature. You can remove the printhead, soak the spray hole with clean 50-60 degrees drinking water for 3-5 minutes, note that the spray hole can be soaked, the water level should not be higher than the circuit contacts, and then use a clean paper towel to lightly print the spray hole, clean the water stains and then install the machine to use.