Grey PVC Skirting Board Trim Self-Adhesive,Flexible Skirting Boards Covers,Peel and Stick Wall Base Board Moulding Strip,Baseboard Molding Tape(24M L,6cm W)

• Self -adhesive design: 2 mm (thickness) x 6 cm (width) x 24 meters (length) and the width of the toe is 1.1 cm. soft, waterproof, durable, easy to clean. This pvc wall base material ensures the product does not deform it during long term use.
• How to install: Before installation, make sure the surface of the adherend is clean.If it is greasy, dusty, it will be difficult to paste. Measure the vinyl sheet and cut to the length you need, peel off the adhesive backing, and stick to a smooth surface. Lastly, press its surface repeatedly to make it fully attached to the wall!
• Flexible: The surface has been specially treated to effectively block scratches .this adhesive back vinyl wall base has a decorative feature while helping to protect the base of wall and floor. This product has a toe design, which can perfectly cover the gaps between floors and walls. And it is very flexible and can effectively deal with curved walls or uneven ground.
• Wide application: The vinyl floor base can stick to almost any smooth surface (tile, plastic, metal, glass, wood, smooth walls, exterior walls). Vinyl wall base self adhesive is widely used as decoration and wall base protection in your living room, bedroom, kitchen, bathroom, garage.
• Tips: If the temperature is below 20℃, please use a hair dryer to heat the backing adhesive tape to achieve the best performance.

How To Install: 1. Before installation, clean the surface of the adherend .If it is greasy, dusty, it will be difficult to paste. 2.Let the wall base lay flat on the ground for a period of time. 3. Cut to desired length. 4. Peel off the red film. 5. If the temperature is below 68°F, please use a hair dryer or heat gun to heat the adhesive strip to achieve the best performance . 6. Stick it on the wall, and press repeatedly to make it fully contact the wall. 7.NOTE:It’s recommended to keep 24 hours for more stability, don’t try to pull it up until it gets completed the installation. How To Handle Corner? 1.Make a slight cut at the mark to form a seam for easily folding 2.Peel off the adhesive backing and stick to the smooth surface