Finerfilters E-Chen Booster Pump Kit including Pump, Pressure Gauge and Pressure Switch (75GPD)

• 1x Echen Booster pump – (75GPD)
• 1x DMFIT Strainer
• 1x Pressure Gauge
• 1x High-Pressure Switch
• 2x 3/8” to 1/4” elbows for pump. (PTFE Taped), Bypass assembly, Electrical connectors

NOTE: This kit will only work with units that use a float valve or water stored in a pressurised container. The booster pump kit by Finerfilters allows you to convert your unpumped domestic reverse osmosis system into an automated pumped system. The high-pressure switch allows the pump to switch itself off once the storage tank is full. Without the high-pressure switch, the booster pump would need to be turned off manually. For aquarium systems, the pump would only switch itself off if you have a float valve or are storing the RO water in a pressurised container. The high-pressure switch sits in-line on the tubing to your tank and senses a build-up of pressure once the tank is full. The switch, which is married up to the pump via electrical connectors, switches off the pump once the pressure reaches over a certain point (pre-set at 40 PSI, but is adjustable if you would like to fine tune this). The bypass assembly allows you to change the output pressure on your booster pump. Some pumps come with adjustable allen screws that can reduce the pressure output of the pump if required. However, this method of adjusting the pressure can sometimes be a pain, as you must awkwardly fine tune the tiny allen screw in the booster pump head with an allen key. With the bypass assembly, a ¼” shut off valve is used to allow some of the water to skip the booster pump which will reduce the pressure output if it is too high. You can also tune the pump output by hand if you use the 1/4“shut off valve. The kit comes with all necessary fittings and installation instructions. Minimum operating pressure = 2 BAR / 29 PSI