L Shape 2 Pin Right Angle Corner Solderless Connectors 2Pin 8mm LED Light Connector 2pin L Connectors for RGB 3825 (2PIN-8)

• These 2-pin LED strip connectors are made of PBT material, heat resistant, fire resistant , safe to use.
• 2 pin conductor for 8mm wide 3528 2835 single color LED strip. (Not suitable for high intensity 120LEDs/M strips)
• Compatible with both waterproof and non-waterproof light strips, please peel off silicon on the waterproof strip surface around soldering area before using.
• Working Condition: 0-24V voltage. Suggested maximum load current 4 Amp; Heat resistance level from -20 ~ 100℃.
• Package includes: 10x 2pin 8mm SMD3825 2835 Led strip connectors.

Feature: These L shape connectors for Single Colour 3528/2835 LED light strips comes with 2 easy-clasp connectors and a 90 degree L shape PCB board. You can attach it with your light strips directly without any tools or wielding operations. The wireless design ensures seamless layout when you need to spread your light strips around sharp corners. Compatible with both non-waterproof and waterproof 8mm 2 pin Single Colour LED light strips. Installation tips: Open the cap on the connector and slide in the led strip. Make sure the poles match correctly, then clasp the cap. For waterproof light strips, you need to peel off the silicone around the soldering line first. Important note: If the LEDs flicker or do not light up, it is because there is poor contact between the connector and the LED strip. To solve the problem, please follow these steps: 01.Power on your LED strip. 02.Open all the caps of the connector. 03.Insert your LED strip into the connector, slightly pull and push your LED strip to adjust the contact points between the 2 copper contacts on your LED strip and the 2 prongs in the connector. If the LEDs still do not light up, please use your finger to press a little hard on the 2 prongs in the connector. 04.If the LEDs still do not light up, please adjust the contact points between the 2 copper contacts on the L-shape PCB board and the 2 prongs in the connector, until you see the LEDs light up. Then you can close all the caps of the connector.