Eltako FT55-SZ Wireless Switch Battery and Wirelessly with Rocker/Double Rocker 1 Piece Black

• Wireless button, black, battery and wireless, with rocker and double rocker
• Transmitter/remote control for installation switch programs
• Signal transmission
• Remote control
• Touch sensor

Wireless button, 80 x 80 mm outside, frame inner dimensions 55 x 55 mm, 15 mm high. Generates the energy for radio telegrams even at the press of a button, therefore without connection cable and no stand-by loss. Included are the frame R, a rocker W55, a double rocker DW55 (all the same colour), a mounting frame BRF, the retaining plate HP, the radio module and an adhesive film. Radio buttons with a rocker can send two evaluable signals: press the rocker at the top and press the rocker at the bottom. Wireless buttons with double rocker can send four evaluable signals: two rocker switches each top and bottom. The retaining plate can be screwed onto a flat surface or glued to the wall, glass or furniture with the enclosed adhesive film. Over a 55 mm switch box, the sleeves in the box are used for screw mounting. Then the wireless button lighting FTB can also be clipped to the retaining plate from the back. From the factory, the double rocker is snapped onto the radio module. If this should be replaced with the large rocker switch, then pull the rocker halves forward and do not bend towards the middle. Then click on the large rocker so that their markings 0 and I on the back correspond to the radio module. When gluing, first stick the set retaining plate with frame and mounting frame with the latches at the top and bottom. Then click the radio module set with rocker switch - marking 0 on the back at the top. Before screwing on, loosen the frame with mounting frame from the retaining plate. To do this, press the latches of the retaining plate outwards. Then screw on the retaining plate with the latches at the top and bottom, snap the frame with the mounting frame and snap the radio module set with rocker - marking 0 on the back always at the top. For screw mounting, we recommend sheet metal countersunk screws 2.9 x 25 mm, DIN 7982 C. Both with dowels 5 x 25 mm as well as 55 mm switch boxes.