Eltako FT55-AN Wireless Button, Battery- and Wireless, with Rocker/Double Rocker

• Wireless button anthracite, battery and wireless, with rocker and double rocker
• Transmitter/remote control for installation switch programs.
• Signal transmission.
• Remote control.
• Touch sensor.

Wireless switch, 80 x 80 mm outer, frame inner dimensions 55 x 55 mm, 15 mm high. Generates the power for radio telegrams even at the touch of a button, therefore without connection line and no stand-by loss. Included are the frame R, a rocker W55, a double rocker DW55 (all the same colour), a mounting frame BRF, the mounting plate HP, the radio module and an adhesive film. Wireless button with a rocker can send two evaluable signals: press rocker at the top and press rocker at the bottom. Wireless button with double rocker can send four evaluable signals: press two rocker switches each top and bottom. The mounting plate can be screwed onto a flat surface or glued to the wall, glass or furniture with the enclosed adhesive film. The sleeves in the box are used for screw mounting over a 55 mm switch box. Then the wireless button lighting FTB can also be snapped to the mounting plate from the back. At the factory, the double rocker is snapped onto the radio module. If these are to be replaced with the large rocker, then pull off the rocker halves forward and do not bend towards the middle. Then snap the large rocker switch in such a way that their markings 0 and I on the back correspond to the radio module. When gluing, first stick the set retaining plate with frame and mounting frame - with the latches at the top and bottom. Then snap the set radio module with rocker switch – marking 0 on the back always at the top. Before screwing on, loosen the frame with mounting frame from the mounting plate. To do this, press the latches of the retaining plate outwards. Then screw on the retaining plate - with the latches at the top and bottom - snap the frame with the mounting frame and lock the set radio module with rocker - marking 0 on the back always at the top. For screw mounting, we recommend sheet metal countersunk screws 2.9 x 25 mm, DIN 7982 C. Both with dowels 5 x 25 mm and on 55 mm switch boxes.