BONA MEGA SILKMATT for Wooden Floors 1Litre WT133313012

Product description Easy to use and highly resistant to scratches, scuff marks and wear, it's easy to see why the Bona Mega product is a popular choice with DIY enthusiasts, hardwood flooring specialists and shop fitters alike. Safe, quick & easy to use Can be applied with a roller, brush or floor applicator Drying time of around 3 hours Highly resistant to wear, scuff marks & scratches Bona Mega has very good chemical resistance Bona Mega surface preparation Surfaces should be sanded back to bare wood and be free of all sanding dust, grit, dirt, oil, wax and any other contaminates. The final sanding should be done with a fine sanding disk, screen or good quality sandpaper with a sanding grit of 120 or finer. Floors that have been previously treated with wax, polish or similar products cannot be overcoated with Bona Mega Bona will not guarantee good adhesion when overcoating finishes of a brand other than Bona. Apply Bonakemi Mega to a small test area to confirm performance and compatibility. Before application, ensure contents is shaken thoroughly. Bona Mega is best applied in thin coats with a roller in a smooth flowing action and avoiding any excess. Ensure room temperature does not fall below 13C during application and drying of this product. Bona Mega on previously finished flooring With an addition of 2% Bona Crosslinker, Bona Mega will normally have very good adhesion properties on pre-finished flooring, it is advisable however to check the intercoat adhesion prior to overcoating. To check intercoat adhesion, apply a coat of Bona Mega to a small test area as described above i.e. sanded and clean, allow the coating to set for 3 days then scratch the treated floor surface gently with a coin. If the Bona Mega finish stays firmly attached to the test area, the adhesion is satisfactory. Preparation of factory pre-finished floors Prior to application of Bona Mega to factory pre-finished floors, the flooring must be treated with the Bona Prep system in accordance ... Directions Prepare the surface by sanding it down to bare wood and ensuring it is free of dust, grit, dirt, oil, wax, and other contaminants. Use a fine sanding disk, screen, or sandpaper with a grit of 120 or finer for the final sanding. Shake the varnish thoroughly before use. Apply the varnish in thin coats using a roller in a smooth, flowing motion, avoiding excess. Ensure the room temperature does not fall below 13°C during application and drying. For previously finished flooring, use 2% Bona Crosslinker to ensure good adhesion, and check intercoat adhesion before overcoating. Treat factory pre-finished floors with the Bona Prep system prior to application.