AZDelivery UART-TTL USB Adapter 3.3V 5V CH340G Interface Converter Module, with 20cm Jumper Cable, compatible with Arduino Including E-Book! (Pack of 5)

• ✅ Configuration with jumpers allows for switching between 3.3V and 5V (supply voltage as well as logic level)
• ✅ Ready to operate and easy to use: Based on the widely used CH340G chip, its USB-TTL interface is ready for use and installed on the adapter without additional manual driver installation. configuration with jumpers allows for switching between 3.3V and 5V (supply voltage as well as logic level)
• ✅ Safe Operation: the USB adapter is protected by a fuse against the risk of the USB port being damaged
• ✅ Direct Communication: Works with damaged microcontrollers if communication via USB is no longer possible, the adapter can be used to directly communicate with the chip
• ✅ This product includes an E-Book that provides useful information on how to begin your project, it helps with a quick setup and saves time on the configuration process. We provide an array of application examples, full installation guides and libraries.

AZDelivery USB UART-TTL Adapter 3.3V 5V CH340G Interface Converter Module including E-Book! The USB adapter is intended for connecting microcontrollers to the PC, it supports Serial communication, TTL and UART. This adapter can help if the communication via the built-in USB interface with a microcontroller no longer works. It enables a direct connection to the chip and creates the option of direct programming. The adapter supports 3.3V and 5V output voltage or logic level. You can switch between the two voltages by changing the position of a jumper. The corresponding positions for 3.3V and 5V are marked on the board. Three LEDs signal to the user what is happening in real time. The blue LED lights up when there is a stable power supply, the red LED flashes when data is being transferred to the microcontroller and the green LED signals that the adapter is receiving data from the microcontroller. The built-in fuse protects the USB port against damage caused by an overvoltage. The fuse resets after a few minutes and the adapter can be reused. If necessary, two additional pins for CTS and RTS can be soldered in. However, these are not necessary for normal use. The adapter is supplied with cables to connect a microcontroller. For top quality Raspberry Pi products, AZ-Delivery Vertriebs is your go to. We provide an array of application examples, full installation guides, eBooks, libraries, and all round assistance. AZ-Delivery, your microelectronics expert.