AlveyTech 3-Wire Thumb Throttle for the Hover-1 Alpha Electric Scooter - Replacement Finger Speed Control with 3 Pin Female Connector, Accelerator Controller Parts for Scooters

• For Slotted Handlebars - Works with slotted handlebars to allow the internal key to slide unto the handlebars. This will not work with standard round handlebars without a slot
• Female End Connector – This throttle includes the female connector end, not the male end. Review images to verify the connector matches your existing connector
• Compatibility – This thumb throttle will work on the Hover-1 Alpha
• Easy Plug N' Play Installation – The included 7” wiring harness helps to make installation a breeze even if you have no DIY repair experience
• Easy Grip - Features a textured silicone thumb pad and ergonomic design for durability and effortless speed and acceleration adjustments

Do you need a new throttle for your electric scooter? If so, then you have come to the right place for replacement parts and accessories! Take a look at this AlveyTech 3-wire thumb throttle. The thumb throttle, sometimes referred to as a finger speed control or accelerator, is one of the most important pieces of your electric scooter. This throttle is compatible with the Hover-1 Alpha electric scooters for adults. Review images to verify the connector matches your existing connector. It comes with a 7" wiring harness with a white 3-pin female connector, making it easy to install. Please note, this throttle comes with an internal key, or nub, that will slide into slot on slotted handlebars. So, what are you waiting for? Don’t let a broken or malfunctioning throttle slow you down. Add one or more of these throttles to your cart today! MODEL COMPATIBILITY Hover-1: Alpha SPECIFICATIONS Throttle length: 2-7/16” (6.19 cm) Throttle width: 1-1/16” (2.70 cm) Wire harness length: 7” (17.78 cm) INSTRUCTIONS -Disconnect battery -Remove grip -Loosen set screw on bottom of throttle -Disconnect throttle harness from the main harness (access may differ between models) -Slide throttle down about an inch and remove rubber insert from handlebar slot -Gently pull harness through and slide throttle off handlebar -To install, repeat instructions in reverse being careful to align parts in the slot on the handlebar