2M Shower Threshold Water Barrier,Wet Room Floor Bathroom Dam,Shower Tray Sealing Strip,Kitchen Sink Bathtub Countertop Retaining Strip, Water Stopper Strip(L Shape, 3cm High)

• 【How To Install】:First clean and dry the surface, measure and cut the wet room floor water barrier to your length, peel off the red adhesive back strip, stick to the Smooth Surface.NOTICE:For Long Use, It Is Must To Use Silicone Sealant(Glue) To Fill The Edges Of The Water Barrier And Dry For 24 Hours Until The Sealants Is Solidified(The Package Do Not Contain Silicone Sealant)
• 【High Quality Silicone Material】:The wetroom floor barrier is made of food grade organic silicon, which is corrosion resistant, high temperature resistant, wear resistant. It is thick and reflexible.Only need a wet towel to wipe, it will be clean as new.
• 【Keep Your Home Away From Damp】:Shower Water stopper, ideal for curbless showers and other areas where water needs to be contained:under the shower curtain,beside the shower pan, bathroom threshold, pool mesa,washing machine,basin,closestool,bathtub edge.
• 【Flexible】: Flexible enough to create all sorts of curved shape.Could be applied to flat and smooth tile, glass or ceramics. Works perfectly on the outer edges of the shower pan.A flood barrier for home to keep water stay inside shower，blocks water overflowing.
• 【Size】: The size of the silicone water barrier is 16mm W X 30mm H, Soft enough to be cut to size you need，The bath edging strip is soft and does not hurt your feet.

Cautions: In order to achieve stable and lasting effect , please pay attention to the follow question This floor seal suit for kinds of Smooth flat floor, such as smooth marble floor, coating floor and other smooth surface. can not use for Severe sags and crests floor, big gap floor and Mosaic glass floor. Purchase a size that is 5cm-10cm longer than the required length ! use with silicone sealant: Fill the gap between the walls with the two ends of the water barrier and all around of bottom by silicone sealant to achieve a completely hermetic effect, remove the excess glue to make the contact smooth. Clean the ground and dry it before installation! Not peeling all of sticker one-time: Mark the position and measure suitable length before peeling sticker, peeling sticker little by little one side and then press the peeled position to the surface as the same time, then peeling left little by little. Not peeling all of sticker for one-time and pull up the water retaining strip if found its not install well. After the installation is completed, it needs to be kept dry for 24 hours, and it needs to be postponed for 1-2 days in autumn and winter. Installation Method: Measure:Measure the length and width of the countertop, In the corner, we recommend you cut it to 45 degree, and then connect two part to ensure its firmness. Tear off the adhesive: in this process avoiding dust on the adhesive strip and affecting its adhesion. Paste: apply the water dam seal gently and slowly, keeping it horizontal or vertical, pressing gently with your fingers. Glue:The most important and necessary step is to fill the bottom edge of the water retention strip with caulk to ensure a long-lasting and strong adhesion.