200x Weep Hole Vents for Clinker Joint Gaps for retrofitting

• Allows air and moisture out of the masonry. Insects and rodents do not get through the joints behind the clinker brick.
• Shock joint fan for retrofitting - also possible by laymen. Universal use. Easy to cut to size for each joint with scissors.
• Colour: grey – but can also be used so deep that the joint grid is barely visible.
• For joints with a max. Height of 8 cm and a max. Width of 3 cm (can be cut to size)
• Dimensions of the joint grid: approx. 8 x 5.5 cm, material: plastic, pack of 200

An expertly built building with clinker façade has open joints for ventilation of the ventilated masonry. Some animals, such as bees, wasps, mice, rats and other rodents like to use these openings and can cause great damage. The animals eat or transport the insulation. Damage to the insulation creates a cold bridge which results in moisture and mould. Protect your shock joints, even so that mice cannot climb up to the loft behind the clinker brick. Fugitte is a ventilation grille, which can also be easily retrofitted without specialist knowledge and special tools by amateurs in the joint joints of the clinker brick. In addition, it is much cheaper than alternative solutions. In many houses, the butt joints in the clinker brick are not protected against intruders during the construction phase. Therefore, it is important that you can retrofit the protection. The Fugitte joint grille is the ideal protection that makes retrofitting the joint fan possible. Especially if your house is in nature near the forest or fields, you will be particularly affected by these problems. Therefore, it is important to protect these houses in order to prevent damage. Easy to assemble even by amateurs: the Fugitte joint grille can be easily pressed together with your fingers and inserted into the joints. It then expands again and holds firmly in the clinker brick. Thus, the joint fan can be used for joints with different widths. The grout grid can be easily adjusted with scissors and can therefore be used for joints of different heights.