2 Hole Kitchen Mixer Tap 180mm Centers, Dual Lever Chrome Bridge Tap

• 【Dual Water Modes for Efficient Cleaning】 Switch effortlessly between stream for filling kettles and spray for rinsing tough oil stains. The 30° tilt spout extends the cleaning range, accommodating large cookware seamlessly.
• 【Standard 180mm Centers Compatibility】 Built specifically for 2-hole sinks with a precise 180mm center distance (please measure before ordering). The 29cm total height and 17.5cm spout clearance accommodate daily washing tasks.
• 【360° Swivel for 1 or 2 Sinks】 The swan neck rotates a full 360 degrees, providing flexible water access across single or double bowl sinks. The dual lever design ensures independent, safe control of hot and cold water flows.
• 【Anti-Splash Detachable Aerator】 Generates a soft, filtered water flow to prevent splashing onto countertops. The aerator is easily detachable for routine cleaning or replacement, effectively addressing hard water buildup.
• 【Complete DIY Installation Kit】 Package includes the bridge mixer tap, two standard UK flexible hoses, and all required fittings. Constructed with rust-resistant chrome finish over solid internals for long-term household use.

Product Specification Product Name: Bridge Kitchen Mixer Tap Tap Type: Dual-Lever Hot and Cold Mixer Tap Installation Type: Deck-Mounted, 2-Hole Installation Required Hole Centres: 18 cm / 7.1 in Overall Height: 29 cm / 11.4 in Spout Type: High-Arc Swivel Spout Spout Rotation: 360° Outlet Adjustment: Approximately 30° Water Flow Modes: Stream and Spray Aerator Type: Detachable Anti-Splash Aerator Control Type: Separate Hot and Cold Levers Finish: Chrome Package List 1 × Chrome Bridge Kitchen Mixer Tap 1 × Dual-Mode Aerator and Spray Head, Pre-Installed 1 × Braided Hot and Cold Inlet Hoses 1 × Mounting Nuts and Fixing Hardware 1 × Rubber Seals or Washers 1 × Installation Manual Installation Steps Turn off the hot and cold water supplies, then confirm that the 2 sink holes have a centre-to-centre distance of 18 cm. Connect the hot and cold inlet hoses to the corresponding tap inlets, following the product instructions. Insert the threaded mounting connections through the sink holes and secure the tap underneath using suitable washers and fixing nuts. Connect the hoses to the water supply, restore the water slowly and check every connection for leaks before testing both flow modes. Care and Usage Notes Measure the sink holes before ordering; this tap requires fixed 18 cm centres. Confirm the inlet connection size and included fittings before installation. Take care when testing the hot-water lever and adjust the temperature gradually. Do not overtighten threaded connections, as this may damage seals or fittings. Clean the chrome finish with a soft, damp cloth; avoid abrasive pads or harsh cleaning products. Remove and rinse the aerator periodically if the water flow becomes restricted. Professional installation is recommended if the existing plumbing or sink-hole spacing is unclear.