2-Gang Socket Spacer 15mm Ivory - UK Made Double Back Box Extender for Tiled, Acoustic & Slat Walls

• 15mm depth boost for UK double sockets - lifts the faceplate 15mm clear of the wall, restoring a flush fit when sockets are recessed below tiled, panelled, acoustic or splashback surfaces
• Fits standard UK 2-Gang back boxes - 146mm (W) x 86mm (H) outer, 120.6mm internal width, 5mm radius corners; drops between any standard double faceplate and its back box
• Acoustic and slat-wall ready - designed for slat-wall, MDF and decorative panel installations where panel depth pushes the socket too deep below the surface
• Easy installation - mounts between wall and faceplate, no back box replacement, no rewiring; longer faceplate screws may be required and are not supplied
• Classic ivory finish - matches off-white and warm-toned wall finishes; unbranded face keeps the focus on your socket and faceplate
• UK-made and design-protected - professionally 3D printed in the UK from durable plastic; registered design owned by Alchemy Collectives
• Sold as a single spacer - one 15mm ivory 2-gang spacer per pack

Restore a clean, flush socket finish on tiled, panelled, acoustic or splashback walls with the 15mm ivory 2-Gang socket spacer. When a wall covering pushes the faceplate too far from its back box, this slim accessory lifts the faceplate by 15mm so it sits level with the surface again - no chasing the wall deeper, no back box replacement in most installs. The 146mm x 86mm outer footprint matches every standard UK 2-gang faceplate, with a 120.6mm internal width and 5mm radius corners for a discreet fit. Mounts directly between the wall and the faceplate; rewiring is not required. Note: longer faceplate screws may be needed for installation and are not supplied. Particularly suited to acoustic slat-wall and decorative panel installations, where panel depth makes the faceplate look proud or sunken. Also widely used for kitchen splashbacks, bathroom and utility refits, smart socket upgrades and back-box-mounted USB modules. Each spacer is professionally 3D printed in the UK from durable plastic under a registered design owned by Alchemy Collectives. Supplied as a single spacer in a classic ivory finish.