2-Gang Socket Spacer 15mm Grey - UK Made Double Back Box Extender for Tiled, Acoustic & Slat Walls

• 15MM DEPTH BOOST FOR UK DOUBLE SOCKETS: lifts the faceplate 15mm clear of the wall to restore a flush fit when sockets sit recessed below tiled, panelled, acoustic or splashback surfaces
• FITS STANDARD UK 2-GANG BACK BOXES: 146mm (W) x 86mm (H) outer with 120.6mm internal width and 5mm radius corners, dropping neatly between any standard double faceplate and its back box
• ACOUSTIC AND SLAT-WALL READY: purpose-designed for slat-wall, MDF and decorative panel installs where panel depth pushes the socket too far below the finished surface
• FITS IN MINUTES WITH NO REWIRING: mounts between the wall and the faceplate with no back box replacement; longer faceplate screws may be needed and are not supplied
• MODERN GREY FINISH: blends with grey, concrete and contemporary wall tones, with an unbranded face that keeps the focus on your socket and faceplate
• UK-MADE AND DESIGN-PROTECTED: professionally 3D printed in the UK from durable plastic under a registered design owned by Alchemy Collectives, supplied as one 15mm grey 2-gang spacer

Restore a clean, flush socket finish on tiled, panelled, acoustic or splashback walls with the 15mm grey 2-Gang socket spacer. When a wall covering pushes the faceplate too far from its back box, this slim accessory lifts the faceplate by 15mm so it sits level with the surface again - no chasing the wall deeper and no back box replacement in most installs. The 146mm x 86mm outer footprint matches every standard UK 2-gang faceplate, with a 120.6mm internal width and 5mm radius corners for a discreet fit. It mounts directly between the wall and the faceplate and does not require rewiring. Please note longer faceplate screws may be needed and are not supplied. Particularly suited to acoustic slat-wall and decorative panel installations where panel depth makes the faceplate look proud or sunken, and widely used for kitchen splashbacks, bathroom and utility refits, smart socket upgrades and back-box-mounted USB modules. Each spacer is professionally 3D printed in the UK from durable plastic under a registered design owned by Alchemy Collectives, and supplied as a single spacer in a modern grey finish.