1-Gang Switch Spacer 15mm Grey - UK Made Single Back Box Extender for Tiled, Acoustic & Slat Walls

• 15mm depth boost for UK light switches and single sockets - lifts the faceplate 15mm clear of the wall, restoring a flush fit when switches or sockets are recessed below tiled, panelled, acoustic or splashback surfaces
• Fits standard UK 1-Gang back boxes - 86mm (W) x 86mm (H) outer, 60mm internal width, 5mm radius corners; drops between any standard single faceplate and its back box
• Acoustic and slat-wall ready - designed for slat-wall, MDF and decorative panel installations where panel depth pushes the switch or socket too deep below the surface
• Easy installation - mounts between wall and faceplate, no back box replacement, no rewiring; longer faceplate screws may be required and are not supplied
• Modern grey finish - matches grey, concrete and contemporary-tone wall finishes; unbranded face keeps the focus on your switch or faceplate
• UK-made and design-protected - professionally 3D printed in the UK from durable plastic; registered design owned by Alchemy Collectives
• Sold as a single spacer - one 15mm grey 1-gang spacer per pack

Restore a clean, flush switch or socket finish on tiled, panelled, acoustic or splashback walls with the 15mm grey 1-Gang switch and socket spacer. When a wall covering pushes the faceplate too far from its back box, this slim accessory lifts the faceplate by 15mm so it sits level with the surface again - no chasing the wall deeper, no back box replacement in most installs. The 86mm x 86mm outer footprint matches every standard UK 1-gang faceplate, with a 60mm internal width and 5mm radius corners for a discreet fit. Mounts directly between the wall and the faceplate; rewiring is not required. Note: longer faceplate screws may be needed for installation and are not supplied. Particularly suited to acoustic slat-wall and decorative panel installations, where panel depth makes the faceplate look proud or sunken. Also widely used for kitchen splashbacks, bathroom and utility refits, smart switch upgrades, dimmer modules and back-box-mounted accessories. Each spacer is professionally 3D printed in the UK from durable plastic under a registered design owned by Alchemy Collectives. Supplied as a single spacer in a modern grey finish.